:::RHMT::: Real Home Made Turbo
General Category => General Discussion => Topic started by: runsfromdacops on September 15, 2010, 02:36:10 PM
-
On my down to sandeago for some hydro plane racing this weekend.should be a lot of fun lots of big and little hydros. Stop by and say hi if you in the area. Me and josh will be working on the gp-99 all weekend
-
On my down to sandeago for some hydro plane racing this weekend.should be a lot of fun lots of big and little hydros. Stop by and say hi if you in the area. Me and josh will be working on the gp-99 all weekend
hit up n/a mike!
-
On my down to sandeago for some hydro plane racing this weekend.should be a lot of fun lots of big and little hydros. Stop by and say hi if you in the area. Me and josh will be working on the gp-99 all weekend
hit up n/a mike for Hot Pockets and fat bitches.
-
i could go for a hot pocket :D
-
hit up n/a mike!
that's the last thing i'd fuckin do.
-
;D cool At my shop where i was these guys are there. roostertailracing.com
(https://realhomemadeturbo.com/forum/proxy.php?request=http%3A%2F%2Fwww.roostertailracing.com%2Fimages%2F102_2452.JPG&hash=789c75ca1ad15e30d2f1022d0085edfc1384bc82)
Was there when they just put in the new motor.Guys are cool I rent the same place they do. We have a few beers on the weekends when there there working. :o There in calli testing the new hydro the just got finish putting together
-
2 motors this weeknd so far. ouch.
-
um....as far as i can tell that motor has no intercooler? why dont they run one of those water/air ic's that go between the blower and manifold?
or are they running meth?
-
Straight Alcohol.
-
but still couldnt you run a water/air ic and have awesome air temps. or with alchy is it not much of a difference, im not really familiar with the fuel.
-
They usually have plenty of power as it is. It's a matter of getting the prop to bite and keeping the hull right on the edge of control.
-
Alex is actually down there just fucking dudes in San Fran. Don't fall for the hype. :noel:
-
Actually Alex is down in San Diego at a Spelling Bee. He's not expected to do very well.
-
;D ;D This is fact!!! haha
-
My god, that has got to be making some serious power.
-
um....as far as i can tell that motor has no intercooler? why dont they run one of those water/air ic's that go between the blower and manifold?
or are they running meth?
but still couldnt you run a water/air ic and have awesome air temps. or with alchy is it not much of a difference, im not really familiar with the fuel.
if you put rubbing alcohol on your hand its cold much the same when it gets injected into an intake manifold.
Some tractor puller and drag racing guys have a problem of icing up the intake due to a lot of fuel at very high pressures.
an I/C would cause the situation to be worse.
When I ran my dsm on straight ethanol (scored from work) i didnt run an intercooler and after a run my intake manifold depending on weather was either
slightly warm to damn near freezing. I am planning on running a lowish boost setup on e85 with either a air/water or no I/c at all
-
If I keep my car an outlaw car, I'm ditching the intercooler and BOV. I don't think it's worth the 40lbs for what I get on a drag only car.
-
2 motors this weeknd so far. ouch.
the motor make 1500hp and he says the intake charge doesnt get above 120 degrees alchol injected
-
2 motors this weeknd so far. ouch.
the motor make 1500hp and he says the intake charge doesnt get above 120 degrees alchol injected
Its kinda the same thing how c02 or propane tanks get cold when they vent something going from high pressure liquid to low pressure vapor with pull
heat out of the surrounding air to vaporize the liquid thus cooling the charge. think nitrous
-
endothermic heat transfer.
-
endothermic heat transfer.
Sounds like a bad fart
-
Man you guys missed out. It was a blast! Ill post some pics and info when I get home
-
;D cool At my shop where i was these guys are there. roostertailracing.com
(https://realhomemadeturbo.com/forum/proxy.php?request=http%3A%2F%2Fwww.roostertailracing.com%2Fimages%2F102_2452.JPG&hash=789c75ca1ad15e30d2f1022d0085edfc1384bc82)
Was there when they just put in the new motor.Guys are cool I rent the same place they do. We have a few beers on the weekends when there there working. :o There in calli testing the new hydro the just got finish putting together
vary cool boat/ guys they were next to us in the pits, they took 1st in the 4th heat of the weekend all becus everyone else way DQ.that boat did well for being 3/4 done