:::RHMT::: Real Home Made Turbo

General Category => General Discussion => Topic started by: speedjunky01 on July 29, 2009, 09:04:08 PM

Title: in soviet russia, the head mills you!!
Post by: speedjunky01 on July 29, 2009, 09:04:08 PM

lol

planar volvo topp (http://www.youtube.com/watch?v=a30NNVgwQLQ#lq-lq2-hq-vhq)

planar volvo topp (http://www.youtube.com/watch?v=a30NNVgwQLQ#lq-lq2-hq-vhq)

Title: Re: in soviet russia, the head mills you!!
Post by: t_cel_t on July 29, 2009, 09:42:13 PM

hahaha, i would think that would make the head look like this \/, not that much of a v but not good

Title: Re: in soviet russia, the head mills you!!
Post by: speedjunky01 on July 29, 2009, 10:48:42 PM

its cool they hit it with a die grinder at the end lol

Title: Re: in soviet russia, the head mills you!!
Post by: stealthiskey on July 30, 2009, 01:08:08 AM

that shit works better than you think!  do it on small two strokes all the time!  and by all the time i mean once or twice, and who cares if the head leaks anyhow? its not important or anything

Title: Re: in soviet russia, the head mills you!!
Post by: d-rail on July 30, 2009, 05:29:35 AM

Old school. lol

Title: Re: in soviet russia, the head mills you!!
Post by: DRQPQUT on July 30, 2009, 12:13:03 PM

Quote from: d-rail on July 30, 2009, 05:29:35 AM

Old school. lol

been there done that..i had a pressure washer at work vapor locked on me so i took a piece of sandpaper put it on a drill bit and re did the bearing slapped it together and to my surprise worked just had a slight rod knock