:::RHMT::: Real Home Made Turbo

General Category => Forced Induction => Topic started by: b20beast on September 09, 2009, 08:20:48 PM

Title: Holset H1B / b16a??
Post by: b20beast on September 09, 2009, 08:20:48 PM

Will this turbo be too small for my b16a motor?
H1B Holset turbo, I am looking for about 400whp.

Motor is Forged with SRP Slugs
And R Cams

These are the codes on the plate of turbo

sn 739409
engine 127-0337
h1b
assy 3520851

Title: Re: Holset H1B / b16a??
Post by: ApexSilver06MR on September 09, 2009, 08:28:21 PM

pics?

Title: Re: Holset H1B / b16a??
Post by: b20beast on September 09, 2009, 08:33:40 PM

no pics
compressor seems tiny

backend looks biggish

Title: Re: Holset H1B / b16a??
Post by: widebody93 on September 09, 2009, 08:43:10 PM

Man up and buy a better turbo.

Title: Re: Holset H1B / b16a??
Post by: HiProfile on September 11, 2009, 12:38:59 AM

That being the case, I don't think it would make it, not without lots of shit done to the head. If you measured both wheels (both the large and small ends of each), we could give you a better idea.