:::RHMT::: Real Home Made Turbo
General Category => Hybrid/Tech => Topic started by: 1991civicsi on September 23, 2009, 09:11:47 PM
-
I picked up a used cable trans in good condition which came out of a 1990 Civic Si. I pulled the axle seal to measure the bearing size which was 35mm.
The research I found was that Si trans are 40mm bearing size. Can anyone confirm this? Can it be Si gearing and have a 35mm bearing ?
-
what the code on the case at the fill/drain plugs
-
A00
-
you bought a dx transmission
si=booooooo on the case
-
Thanx Chris.
-
you bought a dx transmission
si=booooooo on the case
could also be a hf/std/ex/etc.
SI can also have
3000
6000
9000
-
ex has the 40m correct? I have never had my hands on one
-
ex has the 40m correct? I have never had my hands on one
IIRC its still 35mm, the 92+ went to 40mm
have to get bone in here to verify
-
Chris, you still have that cable Si trans to sell me?
-
Long gone all I have is a butt load of hydro ex/si stuff
-
ex has the 40m correct? I have never had my hands on one
IIRC its still 35mm, the 92+ went to 40mm
have to get bone in here to verify
verified
-
Chris, you still have that cable Si trans to sell me?
cook him some all meat lumpia and shoot him $20 for personal delivery and call it even...
thats what i did
-
C meat lumpia
lumpia is so good!!!! My best friend is a flip, and growing up we would eat American food at my house, and then go eat flip food at his. Man i love flip food.