:::RHMT::: Real Home Made Turbo

General Category => Hybrid/Tech => Topic started by: highroller54 on October 09, 2009, 05:30:58 PM

Title: the dont have time to fuck around questions
Post by: highroller54 on October 09, 2009, 05:30:58 PM

How much p2w clearance for some srps in 300hp a z6, and any write ups on notching a block for eagle rods?

Title: Re: the dont have time to fuck around questions
Post by: jagojon3 on October 09, 2009, 06:06:47 PM

As for the p2w clearance, you could always give SRP a call and have an answer within minutes if you can't find it through a google search.

Block notching included here

http://theoldone.com/articles/d_series_engine_building_tips/ (http://theoldone.com/articles/d_series_engine_building_tips/)

Title: Re: the dont have time to fuck around questions
Post by: ryan89crx on October 09, 2009, 06:07:50 PM

SRP is going to tell you .0028 or something along those lines

i went .0035 to compensate for expansion with my SRPs

Title: Re: the dont have time to fuck around questions
Post by: highroller54 on October 10, 2009, 11:31:20 AM

srp lists .0030-.0040 so your right in there (JD agrees to). That link is perfect for notching, thanks guys!

Title: Re: the dont have time to fuck around questions
Post by: Joseph Davis on October 10, 2009, 11:56:04 AM

 :noel: