:::RHMT::: Real Home Made Turbo

General Category => Hybrid/Tech => Topic started by: sleepingciv on October 29, 2009, 10:57:47 PM

Title: crank for a y7
Post by: sleepingciv on October 29, 2009, 10:57:47 PM

can i use any 1.6 sohc crank in a y7??
zc a6 z6 y8

Title: Re: crank for a y7
Post by: theidealone on October 30, 2009, 02:34:55 PM

As long as its got the same snout size. I am using a Z6 crank in my ZC, and Im about to use another Z6 crank in an A6.

Title: Re: crank for a y7
Post by: theidealone on October 30, 2009, 06:03:38 PM

Should only be 2 sizes. 22 or 24mm.

Title: Re: crank for a y7
Post by: ryan89crx on October 30, 2009, 07:20:49 PM

Quote from: c0mpl3x on October 30, 2009, 06:53:37 PM

Quote from: theidealone on October 30, 2009, 06:03:38 PM

Should only be 2 sizes. 22 or 24mm.

snout, right?

yes

Title: Re: crank for a y7
Post by: sleepingciv on November 03, 2009, 08:26:36 PM

thanks guys

and im pretty sure the smaller snout was only in the 1988 motors

Title: Re: crank for a y7
Post by: ryan89crx on November 04, 2009, 01:34:17 AM

Quote from: c0mpl3x on November 03, 2009, 08:37:02 PM

does a zc crank fit in a y block?

yes, so will the z6/a6/a1, although as stated above early '88 a6 cranks had a smaller snout and IIRC some differences in cam gears. also the 86-87 dohc motors had a smaller snout as well, while the 88-89 were the large snout. i have to do some research to make sure this is 100% correct, but i believe it is