:::RHMT::: Real Home Made Turbo
General Category => Fabrication => Topic started by: 7808 on July 18, 2010, 11:10:33 PM
-
im sure someone on here has made one of these before, but just in case heres a thing i made out of shit layin around
(https://realhomemadeturbo.com/forum/proxy.php?request=http%3A%2F%2Flh3.ggpht.com%2F_wB07A_tdxe8%2FTEPAeiHRaQI%2FAAAAAAAAAPk%2F_j80dEo43K8%2Fs576%2FIMAG0013.jpg&hash=6be5db040606a4e0429f88a71ee00736f7beac4a)
took a cheap 4" c clamp and tried to wire wheel as much of the already half burned up from welding coating off the one side and hit the little pivot deal too, cut 2 pieces off some angle i had and welded . works good for tacking pipes together instead of tape or magnets sometimes
-
sweet
-
arc welding gloves and my left hand works well too
-
I have been thinking about doing the same thing but with one of those vicegrip style welding clamps.
-
then when youre done welding you take that bad boy outside and put it to lil streetblockas cranium a few times to expand it for 3" pipe
-
fuck yes...
this is why i love rhmt
-
Sweet. I was going to buy the Hobart pliers. I'm going murder a C-clamp.
-
Simple and it works.
Nicely done.
-
piece of long angle iron in a vice works pretty well to
-
Not under a car
-
unless youre tigging shit, i dont see the need