:::RHMT::: Real Home Made Turbo
General Category => Forced Induction => Topic started by: Atticus on May 07, 2009, 02:12:21 AM
-
they any good
buddy has some 750s that im interested in and are willing to trade him my 1000cc precision (too big for my app)
-
i think simens are precisions
-
Gay porn? lulz
-
seimens are not precision.
they are good injectors, i use some seimens 650's. you will have to use a bigger spacer under your fuel rail though. they are a little taller than honda injectors
-
I have a siemen injector.
Someone had to say it.
-
I was hoping i wasnt the only one laughing like Butt-headl at the thread title.
-
I was hoping i wasnt the only one laughing like Butt-headl at the thread title.
hahahahah my bad
-
seimens are not precision.
they are good injectors, i use some seimens 650's. you will have to use a bigger spacer under your fuel rail though. they are a little taller than honda injectors
what spacer did you use?
-
I just used a few washers, ans cut the sholder of the plastic injector down a toutch. Bone has a write up on how he did it some ford injectors. Its the same kinda setup.
-
seimens are not precision.
they are good injectors, i use some seimens 650's. you will have to use a bigger spacer under your fuel rail though. they are a little taller than honda injectors
what spacer did you use?
i used some spare fuel rail nuts screwed down till it hit the shank and then put the fuel rail on.
ratcityrex is right about grinding down a little bit of the plastic too. i forgot about that