:::RHMT::: Real Home Made Turbo

General Category => Forced Induction => Topic started by: walter on May 06, 2013, 02:16:59 PM

Title: question about EK injectors
Post by: walter on May 06, 2013, 02:16:59 PM

Hi guys, i have to build a cheap turbo kit for a custom, since im not sure what injectors has this engine (D14z2), i was wondering if these are low or high impedance, car is a EK 99 year and i will put 345cc injectors (330cc on crome), do i need resistor box for install these injectors in this car? i will use Z6 head too since this engine isnt vtec (just 90hp).

Title: Re: question about EK injectors
Post by: walter on May 06, 2013, 02:19:08 PM

btw, injectors came from Prelude 92-96 345cc

Title: Re: question about EK injectors
Post by: Minor Threat on May 06, 2013, 05:58:08 PM

Do you have the original injectors to measure? Pretty simple if you do.

Title: Re: question about EK injectors
Post by: HiProfile on May 07, 2013, 01:05:41 AM

Yes you will need to run resistors. The 345cc prelude injectors will be low resistance (peak&hold). The original d14z2 injectors should have been saturated and either 235cc or 180cc.

Title: Re: question about EK injectors
Post by: walter on May 07, 2013, 03:28:30 PM

Thanks Profile!