:::RHMT::: Real Home Made Turbo
General Category => Engine Management => Topic started by: walter on June 21, 2018, 06:40:52 AM
-
Hi! Im having a problems with a ecu i chipped yesterday, kit from xenocron (C51/C52 non needed) , ecu is a P28, it Works good but after some minutes i get solid cell. i dont know where is the problema exactly. any input? today it Works good again, didnt touch nothing, it was connected yesterday, today tried to start car and Works good..
-
Had similar issues before, it was a loose connection/not enough solder on one of the components installed in ecu to make chipping work.
Maybe software needs an update, or ostrich cable is damaged, or a loose wire.
No CEL code at all ? :noel:
-
finally got a pirate Socket tester..resoldered everything and worked good
-
finally got a pirate Socket tester..resoldered everything and worked good
Pirate socket tester?
-
Yes, similar than Hondata Socket tester.