:::RHMT::: Real Home Made Turbo
General Category => Forced Induction => Topic started by: Boostedeg on January 17, 2019, 01:24:22 AM
-
New to the forum. Building a 92 e.g. sedan d16z6 speed factory forged pistons an vitara rods, stock head maybe some slight porting, stock intake manifold. Shooting for 300hp.. I have found a wh1c with the 12cm housing for a good peice question is is it to big?? Dont wanting somthing that will start spooling at 5k when red line is 7600 rpm.. Im all ears so please let me knw or give me ideas ect
-
If you were going for bigger power I would say go for it. For the power level your shooting for, I would pick a smaller t3.
-
Any recommendations?? I'm shooting for 3-400.. I would be happy with 300.. Any 1 have any luck with the ebay turbos?? Emusa??
-
used gt28rs
-
I know Ryan (malichite) did like 275hp on his dohc zc with a Ebay 57 turbo. Think it was in the neighborhood of 15psi. He didn't have any problems with it. I mean if I were you, I would look for a used holder hy35 with a 9cm housing. Or a Ebay gt28 or gr32 with a smaller t3 housing. If your trying to stay on a low buck budget.