Topic: crank for a y7 (Read 6164 times)

sleepingciv · « **on:** October 29, 2009, 10:57:47 PM »

can i use any 1.6 sohc crank in a y7??
zc a6 z6 y8

theidealone · « **Reply #1 on:** October 30, 2009, 02:34:55 PM »

As long as its got the same snout size. I am using a Z6 crank in my ZC, and Im about to use another Z6 crank in an A6.

theidealone · « **Reply #2 on:** October 30, 2009, 06:03:38 PM »

Should only be 2 sizes. 22 or 24mm.

ryan89crx · « **Reply #3 on:** October 30, 2009, 07:20:49 PM »

Quote from: c0mpl3x on October 30, 2009, 06:53:37 PM

Quote from: theidealone on October 30, 2009, 06:03:38 PM
Should only be 2 sizes. 22 or 24mm.

snout, right?

yes

sleepingciv · « **Reply #4 on:** November 03, 2009, 08:26:36 PM »

thanks guys

and im pretty sure the smaller snout was only in the 1988 motors

ryan89crx · « **Reply #5 on:** November 04, 2009, 01:34:17 AM »

Quote from: c0mpl3x on November 03, 2009, 08:37:02 PM

does a zc crank fit in a y block?

yes, so will the z6/a6/a1, although as stated above early '88 a6 cranks had a smaller snout and IIRC some differences in cam gears. also the 86-87 dohc motors had a smaller snout as well, while the 88-89 were the large snout. i have to do some research to make sure this is 100% correct, but i believe it is

News:

Author Topic: crank for a y7 (Read 6164 times)

sleepingciv

crank for a y7

theidealone

Re: crank for a y7

theidealone

Re: crank for a y7

ryan89crx

Re: crank for a y7

sleepingciv

Re: crank for a y7

ryan89crx

Re: crank for a y7