:::RHMT::: Real Home Made Turbo

Please login or register.

Login with username, password and session length
Advanced search  

News:

RHMT DIY Hub Dyno?!?!? check it. (link)

Pages: [1]   Go Down

Author Topic: d16z6 ek civic  (Read 5219 times)

notfastcrx

  • Full Member
  • ***
  • Offline Offline
  • Posts: 192
d16z6 ek civic
« on: October 03, 2010, 12:06:48 AM »
I just bought a 96 hatch with a d16z6 that still needs some wiring done. I plan on keeping it obd2 because I dont want to get stuck not being able to get it inspected in NY.

i know i have to keep the obd2 distributor, and injectors. whats the easiest way to wire up everything? my eyes hurt from trying to read through all of these honda-tech "write ups"

Logged

crttaz

  • Certified OG
  • *****
  • Offline Offline
  • Posts: 1831
  • Old Wise One
Re: d16z6 ek civic
« Reply #1 on: October 03, 2010, 12:55:16 AM »
read anything by Katman on his FFSquad page about this.


Z6 doesn't have the OBD-2 crank angle sensor so you have to wire around it.
Logged
OG before the OG'#039#039s

HiProfile

  • Certified OG
  • *****
  • Offline Offline
  • Posts: 4564
  • Injector Kingpin
Re: d16z6 ek civic
« Reply #2 on: October 03, 2010, 03:42:30 AM »
Assuming they don't chekc the block's code...

AFAIK you don't need the OBD2 dizzy, you can repin the connectors. The z6 dizzy is the only thing that fits it with more than 1 bolt. Then you need to add the crank flux sensor. You'll have to do some hacking, since you do not want to swap on a y8 oil pump & oil pan to get the sensor the normal way. You'll need to find the exact spot, fab a bracket, find a y7/y8 crank gear, then cut the timing cover to fit the mess down there. If you can simulate the sensor successfully, that would obviously be the better route. The PCV setup will be a little different, but that can be dealt with. Beyond that, there's not much else to do, unless you have the z6 IM and a 3-wire IACV.
Logged
they mspainted dildoes in my mom'#039#039s hand, in a picture of her in a hospital bed. -JD
dem gurls need some boobz! -Engloid

crttaz

  • Certified OG
  • *****
  • Offline Offline
  • Posts: 1831
  • Old Wise One
Re: d16z6 ek civic
« Reply #3 on: October 03, 2010, 01:16:27 PM »
no need to add the sensor, there is a wiring work around.

http://technet.ff-squad.com/ckftrick.htm
Logged
OG before the OG'#039#039s

notfastcrx

  • Full Member
  • ***
  • Offline Offline
  • Posts: 192
Re: d16z6 ek civic
« Reply #4 on: October 03, 2010, 11:36:35 PM »
thanks for the info ladies. i appreciate it.
Logged

crttaz

  • Certified OG
  • *****
  • Offline Offline
  • Posts: 1831
  • Old Wise One
Re: d16z6 ek civic
« Reply #5 on: October 04, 2010, 02:36:24 AM »
and fuck you too!
Logged
OG before the OG'#039#039s

DasPoop

  • Certified OG
  • *****
  • Offline Offline
  • Posts: 1761
Re: d16z6 ek civic
« Reply #6 on: October 04, 2010, 11:57:27 AM »
Obd1 dizzy pins DO NOT fit in Obd2 plugs requires some cutting and splicing lucky for you though the dizzy harness is the same colors between the two only the obd2 harness wires are wacky.
Logged
Na mike:"quotquotthe one i had was a real bbw, not just a fat chick, but a huge fat chick"quotquot

notfastcrx

  • Full Member
  • ***
  • Offline Offline
  • Posts: 192
Re: d16z6 ek civic
« Reply #7 on: October 04, 2010, 12:27:24 PM »
is this the distributor harness that would work instead of repinning?

Logged

Towdogg

  • Certified OG
  • *****
  • Offline Offline
  • Posts: 2834
  • Cfm's don't roll through an air intake!
Re: d16z6 ek civic
« Reply #8 on: October 04, 2010, 12:43:10 PM »
Quote from: notfastcrx on October 04, 2010, 12:27:24 PM
is this the distributor harness that would work instead of repinning?



It sure looks like it!     If you were an OG you would make your own....
Logged

danz

  • Certified OG
  • *****
  • Offline Offline
  • Posts: 6783
  • 0-60 in 2.7 seconds
Re: d16z6 ek civic
« Reply #9 on: October 08, 2010, 12:24:20 AM »
if...
Logged
10.510 @ 133.09 mph D16Z6 EJ6
10.912 @ 127.33 mph D16A6 ED6

HiProfile

  • Certified OG
  • *****
  • Offline Offline
  • Posts: 4564
  • Injector Kingpin
Re: d16z6 ek civic
« Reply #10 on: October 09, 2010, 06:50:18 PM »
Quote from: danz on October 08, 2010, 12:24:20 AM
if...

Yeah, and you might be able to build your own fast car IF... :-*
Logged
they mspainted dildoes in my mom'#039#039s hand, in a picture of her in a hospital bed. -JD
dem gurls need some boobz! -Engloid
Pages: [1]   Go Up
« previous next »