Forum > Fabrication
making my 73 ford courier go fast, turn, and stop
ratcityrex:
Wicked!
fastivab6tg25mr:
With the weather so nice and car shows back in action I'm getting motivated to finish this terd. Built some new exhaust after work today, it eliminated almost all of my droning noise by putting it out the back of the truck. i even picked up a few inches of ground clearance. Welded the left bed panel back in for filler neck clearance. Still need to build my axle hump to seal it in. Picked up some Audi R8 coils for all the spark. those will be going in sometime this week.
fastivab6tg25mr:
Installed the R8 coils. Definitely should have done more research first. I was unaware that it required an additional circuit be added to my MS3X to run them at full potential.. Huge thanks to the guys on MT.net for coming through with all the info needed for install.
fastivab6tg25mr:
Updated the MS3X internal wiring with FET drivers for R8 coil hottness.
fastivab6tg25mr:
Mapdaddy 4bar sensor installed. machined out the "kia motors" from the valve cover and am having interchangeable stainless steel inserts made.
Navigation
[0] Message Index
[#] Next page
[*] Previous page