Forum > Hybrid/Tech
problems installing differential
shoeboxbeater:
I am having trouble getting the diff back in the case. It is not sliding in like it came out. What would cause the bearing to bind when I am putting the diff back in? The bearing is seated on the diff and I mic'ed both bearings and both are cocentric and the same size
92CXyD:
Setup? :noel:
turbohf:
the bearing is going to be a tight perfect fit. you need to make sure it goes in completely straight. good luck.
also, metal expands and contracts with heat and cold. so case warm, and bearings cold will be a help...
highroller54:
Going in not perfectly strait or a small burr or dirt/fuzz anything like that. Should go in pretty nice if everything is good.
Starting just a touch off and forcing it can make a burr pretty quick.
jdmhatchracer94:
I use a rubber malet and tap around till it drops I
Navigation
[0] Message Index
[#] Next page