Forum > Engine Management
OLED gauge displays
rawr:
These SSD1306 displays are pretty easy to use with arduino and look pretty decent in light and low light.
I've made these for my center console to display my wideband and fuel pressure sensor.
The fuel pressure sensor is ran entirely by an arduino and cost sub 30 bucks with the arduino, sender and the display.
Here's a link to the github for the arduino code.
https://github.com/clbs/Arduino-OLED-fuel-pressure-and-wideband-o2-display/blob/master/dual_oled_gauge_display.ino
I can make a wiring diagram and explain further if anyone has any questions.
Link to OLED displays:
https://www.ebay.com/itm/0-96-inch-IIC-Serial-White-OLED-Display-Module-128X64-I2C-SSD1306-12864-LCD-GND/332415158671
Link to pressure transducer for fuel pressure:
https://www.ebay.com/itm/Pressure-transducer-or-sender-100psi-5V-Stainless-Steel-for-oil-fuel-air-water/282568485079
I've also designed a panel mount for autocad for these little OLED displays. The mount or PCB might need a little modification to fit. I'm not sure yet. The 3d print is currently in the mail.
They snap together on a panel so they should be decently easy to mount.
Tim:
damn, that's cheap as hell and looks half decent.
Solid work
Ntrain2k:
--- Quote from: Tim on March 26, 2018, 08:15:00 PM ---damn, that's cheap as hell and looks half decent.
Solid work
--- End quote ---
92CXyD:
--- Quote from: Ntrain2k on March 26, 2018, 08:44:08 PM ---
--- Quote from: Tim on March 26, 2018, 08:15:00 PM ---damn, that's cheap as hell and looks half decent.
Solid work
--- End quote ---
--- End quote ---
:noel:
zahid:
hello sir
i want to only show pressure in oled display my pressure transducer in put 5 volt dc and out put is 0.5 to 4.5 volt dc and pressure is 0 to 400 bar
i want to display the pressure in display only please send men the code thanks
i am waiting your replay
Navigation
[0] Message Index
[#] Next page