:::RHMT::: Real Home Made Turbo

Please login or register.

Login with username, password and session length
Advanced search  

News:

Official RHMT TANK! that's right i said a TANK! (link)

Pages: [1]   Go Down

Author Topic: dead cylinder #2, has spark.. halp!  (Read 3778 times)

marcj

  • Marc Jew
  • Certified OG
  • *****
  • Offline Offline
  • Posts: 1956
  • Never alone, Never again. (NA)
dead cylinder #2, has spark.. halp!
« on: August 08, 2009, 10:08:42 AM »

alright, so I had inline resistors which have worked fine up until the latest revision. I got the new setup finished yesterday, but to my dismay, the fucker only runs on 3 cylinders.

#2 cylinder spark plug pulled doesn't change the idle, the rest do; checked spark and it's good.. checked resistor wiring and it is still connected (soldered). Can these things go bad?

I'm about to go check continuity, and injector #2 pin wires near the ecu..

any advice?
Logged

marcj

  • Marc Jew
  • Certified OG
  • *****
  • Offline Offline
  • Posts: 1956
  • Never alone, Never again. (NA)
Re: dead cylinder #2, has spark.. halp!
« Reply #1 on: August 08, 2009, 10:18:31 AM »

btw, i have swapped out injectors, so i'm pretty sure the injectors are fine
Logged

onlyflash944

  • Certified OG
  • *****
  • Offline Offline
  • Posts: 2741
  • Jack of all trades, Master of none
Re: dead cylinder #2, has spark.. halp!
« Reply #2 on: August 08, 2009, 10:42:46 AM »

resistors can burn up, multifunction volt meter is your friend
Logged

You read some forums? nbspnbsp Cool, I tune cars.

  Its your fucking car, if you want to hack it up fucking go for it.

marcj

  • Marc Jew
  • Certified OG
  • *****
  • Offline Offline
  • Posts: 1956
  • Never alone, Never again. (NA)
Re: dead cylinder #2, has spark.. halp!
« Reply #3 on: August 08, 2009, 11:02:26 AM »

I have one, and have tested the resistance on each injector plug.. all respond the same.

I get nothing with the ECU unplugged (obviously).. i'm starting to think my ECU took a crap
Logged

marcj

  • Marc Jew
  • Certified OG
  • *****
  • Offline Offline
  • Posts: 1956
  • Never alone, Never again. (NA)
Re: dead cylinder #2, has spark.. halp!
« Reply #4 on: August 08, 2009, 11:07:50 AM »

I'm getting a solid CEL even after I took my jumper wire out of the DTC plug, so I'm thinking the ecu took a dump.. maybe the injector driver?
Logged

onlyflash944

  • Certified OG
  • *****
  • Offline Offline
  • Posts: 2741
  • Jack of all trades, Master of none
Re: dead cylinder #2, has spark.. halp!
« Reply #5 on: August 08, 2009, 11:13:30 AM »

test with a known good one
Logged

You read some forums? nbspnbsp Cool, I tune cars.

  Its your fucking car, if you want to hack it up fucking go for it.

buk9tp

  • Guest
Re: dead cylinder #2, has spark.. halp!
« Reply #6 on: August 08, 2009, 12:29:36 PM »

I'm getting a solid CEL even after I took my jumper wire out of the DTC plug, so I'm thinking the ecu took a dump.. maybe the injector driver?

what i did was swap injector plugs just to be 100% sure its the injector wiring...

then just ran a wire straight from the ecu to the injector..

solid cel for fried ecu but the only problem is one injector doesnt fire?

idk. wierd...
Logged

marcj

  • Marc Jew
  • Certified OG
  • *****
  • Offline Offline
  • Posts: 1956
  • Never alone, Never again. (NA)
Re: dead cylinder #2, has spark.. halp!
« Reply #7 on: August 08, 2009, 02:51:21 PM »

i'm swapping the whole engine harness tomorrow, and testing the ecu on a scott evans car.
Logged

TheMadScientist

  • Certified OG
  • *****
  • Offline Offline
  • Posts: 1937
  • I'm like Batman and Shit
Re: dead cylinder #2, has spark.. halp!
« Reply #8 on: August 13, 2009, 01:01:49 AM »

I would swap out the ecu with a known good ecu to check it.
Logged
Why would I not be surprised if your pink slip included "quotquotthen Mr Davis overturned the table while shouting, HOWS THAT FOR FLUID MECHANICS?!"quotquot?
Pages: [1]   Go Up