Started a Homemade turbo System.
I decided my Speeduino A Plug and Play unit, I used an old toyota 4Agze obd1 ecu case and went to town on it. I now have have 2 IS9V5056S3S Ignition drivers mounted in the ECU as well.
how the bay looks now
Cleaned up a bit. I tie strapped the Speeduino a bit further up under the dash to clean things up and to try and safe guard it from someone stepping on it.
I never mounted my IAT sensor on my intake piping, I pretty much just had it dangling in the engine bay. I figured there is a huge difference between the air coming in from my cold air intake and what the sensor was reading in the bay so i decided I would just take off the cold air intake since I didn't wanna go through the trouble of lengthening the IAT sensor wires since I will be going turbo soon. I just placed it on the air filter. It will do for now.
Cleaned up the wiring a bit more. I used one of these break out boards and mounted the speeduino in the glove compartment. No I dont have to worry about someone stepping on the ecu on the floor