:::RHMT::: Real Home Made Turbo

Please login or register.

Login with username, password and session length
Advanced search  

News:

ApexSilver06MR/Jason YOU WILL BE MISSED, RIP (link)  :'(

Pages: [1]   Go Down

Author Topic: CEL 43 Help?  (Read 4286 times)

Full Spool

  • Jr. Member
  • **
  • Offline Offline
  • Posts: 28
CEL 43 Help?
« on: October 06, 2010, 07:00:36 PM »

The car is a 2000 si with b20 block and si head, and a crome base map. While cruising the interstate the CEL will come on and then go away when the car is turned off. It comes on almost evertime on the interstate. My crappy helms manual states check fuel supply, regulator and vacuum lines. I have checked all of that fuel psi is around 45psi at idle, and im at a loss on where to begin from here. Any suggestions?

p28 clone obd1 ecu, I've tried a few different maps on different chips with same results.

Logged

92CXyD

  • Twincharged Smeghead
  • Global Moderator
  • Certified OG
  • *****
  • Online Online
  • Posts: 6785
  • I look around and all I see is Smegheads
Re: CEL 43 Help?
« Reply #1 on: October 06, 2010, 07:07:00 PM »

I got the same when I had Al shavings, and wiring harness was damaged.  O0

I believe the ECU picks up the issue when one of the inj. wires from the ecu A-plug is damaged.

That is what I would look at if you have already looked at the FPR, FP, fuel filter, and vac. lines.

Did you use low impedance inj. and a resistor box in this setup?

If so I would look at the solder wires at the resistor box also. :yes:

Teg2boo

  • Certified OG
  • *****
  • Offline Offline
  • Posts: 4261
Re: CEL 43 Help?
« Reply #2 on: October 06, 2010, 07:22:08 PM »

I got the same when I had Al shavings, and wiring harness was damaged.  O0

I believe the ECU picks up the issue when one of the inj. wires from the ecu A-plug is damaged.

That is what I would look at if you have already looked at the FPR, FP, fuel filter, and vac. lines.

Did you use low impedance inj. and a resistor box in this setup?

If so I would look at the solder wires at the resistor box also. :yes:

I think I got this CEL too last week but haven't search about it. Good thing to know.
Logged


damn you guys too? its a fucking forum not a court room!
 Its not a forum its a gang.  

92CXyD

  • Twincharged Smeghead
  • Global Moderator
  • Certified OG
  • *****
  • Online Online
  • Posts: 6785
  • I look around and all I see is Smegheads
Re: CEL 43 Help?
« Reply #3 on: October 06, 2010, 07:56:47 PM »

I got the same when I had Al shavings, and wiring harness was damaged.  O0

I believe the ECU picks up the issue when one of the inj. wires from the ecu A-plug is damaged.

That is what I would look at if you have already looked at the FPR, FP, fuel filter, and vac. lines.

Did you use low impedance inj. and a resistor box in this setup?

If so I would look at the solder wires at the resistor box also. :yes:

I think I got this CEL too last week but haven't search about it. Good thing to know.

I learned this this summer  :-\

Full Spool

  • Jr. Member
  • **
  • Offline Offline
  • Posts: 28
Re: CEL 43 Help?
« Reply #4 on: October 06, 2010, 10:43:55 PM »

It has stock injectors in it now, the car has been a wiring nightmare and hacked into by some ricers.
A new engine hardness has been installed along with stock injectors, it does have a CDM ebay conversion harness so I will check the pins as suggested! Thanks man.

Logged

Teg2boo

  • Certified OG
  • *****
  • Offline Offline
  • Posts: 4261
Re: CEL 43 Help?
« Reply #5 on: October 06, 2010, 10:50:38 PM »

The cell happen after a run at WOT and some boost. Maybe it's due to the vibrations from the engine?
Logged


damn you guys too? its a fucking forum not a court room!
 Its not a forum its a gang.  

Full Spool

  • Jr. Member
  • **
  • Offline Offline
  • Posts: 28
Re: CEL 43 Help?
« Reply #6 on: October 06, 2010, 11:00:18 PM »

Its an NA car, it only happens in 5th gear cruising at 70-75 on the interstate.
Logged

Joseph Davis

  • Verbal Assault Technician
  • Moderator
  • Certified OG
  • *****
  • Offline Offline
  • Posts: 34733
  • Eugenics prevents retards like widebody93
    • TURBO THIS
Re: CEL 43 Help?
« Reply #7 on: October 07, 2010, 06:14:04 PM »

You should post questions like this in the EM forum.

Full Spool

  • Jr. Member
  • **
  • Offline Offline
  • Posts: 28
Re: CEL 43 Help?
« Reply #8 on: October 07, 2010, 11:17:02 PM »

You should post questions like this in the EM forum.


I did originally but a mod moved it.
Logged

HiProfile

  • Certified OG
  • *****
  • Offline Offline
  • Posts: 4564
  • Injector Kingpin
Re: CEL 43 Help?
« Reply #9 on: October 09, 2010, 06:55:38 PM »

Its an NA car, it only happens in 5th gear cruising at 70-75 on the interstate.

Boost will most asuredly make it go away. DO WORK.
Logged
they mspainted dildoes in my mom'#039#039s hand, in a picture of her in a hospital bed. -JD
dem gurls need some boobz! -Engloid

Full Spool

  • Jr. Member
  • **
  • Offline Offline
  • Posts: 28
Re: CEL 43 Help?
« Reply #10 on: October 11, 2010, 12:11:23 PM »

No boost, it isn't my car. I don't drive honduhs anymore.
Logged
Pages: [1]   Go Up