Topic: Solid CEL after some minutes (Read 5817 times)

walter · « **on:** June 21, 2018, 06:40:52 AM »

Hi! Im having a problems with a ecu i chipped yesterday, kit from xenocron (C51/C52 non needed) , ecu is a P28, it Works good but after some minutes i get solid cell. i dont know where is the problema exactly. any input? today it Works good again, didnt touch nothing, it was connected yesterday, today tried to start car and Works good..

92CXyD · « **Reply #1 on:** June 21, 2018, 05:24:03 PM »

Had similar issues before, it was a loose connection/not enough solder on one of the components installed in ecu to make chipping work.

Maybe software needs an update, or ostrich cable is damaged, or a loose wire.

No CEL code at all ?

walter · « **Reply #2 on:** August 01, 2018, 07:20:26 PM »

finally got a pirate Socket tester..resoldered everything and worked good

92CXyD · « **Reply #3 on:** August 03, 2018, 01:11:31 PM »

Quote from: walter on August 01, 2018, 07:20:26 PM

finally got a pirate Socket tester..resoldered everything and worked good

Pirate socket tester?

walter · « **Reply #4 on:** September 10, 2018, 10:06:32 PM »

Yes, similar than Hondata Socket tester.

News:

Author Topic: Solid CEL after some minutes (Read 5817 times)

walter

Solid CEL after some minutes

92CXyD

Re: Solid CEL after some minutes

walter

Re: Solid CEL after some minutes

92CXyD

Re: Solid CEL after some minutes

walter

Re: Solid CEL after some minutes