Topic: How do you know when a wideband o2 sensor is bad? (Read 39192 times)

DmC · « **Reply #30 on:** May 05, 2009, 12:00:27 AM »

Quote from: Joseph Davis on May 04, 2009, 02:11:39 PM

Quote from: bryantaylor on March 08, 2009, 07:09:49 PM
fuck the LC-1. i have a first run, it sucked ass.

It's still more accurate than that AEM POS you have.

Also, Klaus warranties all of his defects. It doesn't matter if you are the original owner, have a receipt, etc, if it's one of the early ones with the glitchy analog outputs consider it replaced.

Dude Phillipe is a good guy to. Innovate has repared my lm-1 twice. Both times it was my fault but there were no questions asked on their end they just fixed it and sent it back.

danz · « **Reply #31 on:** May 09, 2009, 04:07:35 AM »

i love my LC-1... never had any problems and made sure to flash the firmware

been running it for over a year w/o issue

rudebwoy · « **Reply #32 on:** May 10, 2009, 11:40:27 AM »

zeitronix ownz all , and uses the same o2 sensor as 17014. when I have a bad o2 sensor it automatically goes to full lean after warmup. www.zeitronix.com

DmC · « **Reply #33 on:** May 10, 2009, 02:18:30 PM »

Quote from: rudebwoy on May 10, 2009, 11:40:27 AM

zeitronix ownz all , and uses the same o2 sensor as 17014. when I have a dad o2 sensor it automatically goes to full lean after warmup. www.zeitronix.com

Man that doesn't look to bad. I wouldn't mind trying one out.

News:

Author Topic: How do you know when a wideband o2 sensor is bad? (Read 39192 times)

DmC

Re: How do you know when a wideband o2 sensor is bad?

danz

Re: How do you know when a wideband o2 sensor is bad?

rudebwoy

Re: How do you know when a wideband o2 sensor is bad?

DmC

Re: How do you know when a wideband o2 sensor is bad?