Topic: do i can tig weld oil drain adaptar to oil pan? (Read 4448 times)

walter · « **on:** May 18, 2009, 01:34:39 PM »

i will try to get J-b weld but i was wondering if i can use ss rods and try to weld adaptar to oil pan, i got oil lines from Stealthmode..

CSaddict · « **Reply #1 on:** May 18, 2009, 03:49:40 PM »

Of course you can Walter. Just make sure its the same type of material. You will need steel bungs/barbs for a steel pan and aluminum for, well, aluminum. The ones that come with Steve's kits are brass though and wont weld. You could braze them but I wouldn't bother. You should get steel.

t_cel_t · « **Reply #2 on:** May 18, 2009, 04:01:03 PM »

get a rod of silicon bronze. just strike an arc but dont start a pool, then dap the rod in there and it will just suck right into the joint. pretty cool, it is meant for this exact thing, it creates a sealed joint.