Run organic the first thousand miles or so...
Heres what I do (and would with a new car (minus the "tuning" oil change---as they are IDLED around for the most part from the factory).
1.Build motor... Fill with Dino oil and new filter. Get motor up to operating temperature make sure there are no leaks... Heat cycle it once or twice. Shut her down and drain oil through a filter... If you can cut the oil filter open and inspect for metal particles
2. Fill with dino oil again and new filter. Go tune part throttle whilst LEED performs his blackness via lappy... Lots of loading the rings both on accell and decel, riding the brakes on the freeway etc.
About twenty minutes in (Or after a decent part throttle tune has been established) Start tuning boost coilums... By the end of the first HOUR my shits seeing 17-20 PSI and >=550WHP off a LEED Street tune.
I take her home, dump the oil and change the filter out again (Dino oil one last time)....
3. At 1000 Miles....Dump the oil and go to synthetic.
Evidently it works... FUCK babying a car for breakin... It WILL NOT seat the rings for shit. The old addage "break em in hard they run hard" works for more than teenage girls... It works for Race motors, and stock motors alike as well...
The shit is only a buck more than Mobile 1, cheap insurance for me.....