Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[malichite]

Got my hands on a couple old oxygen bottles cheap (thanks noslo)  Made myself a quick catch can.  Cut the ends off, drill welded on -10 on one end for the drain, drilled out 1 1/4" hole for the breather on the other.  Then welded 2 -10s on the side near the top.  Cut a 1" diameter piece of tube the same length as the center section and welded it over the two -10s for a baffle.  Once that was done, weld the shit all back together.  Also took out about 8" in overall length.  Still more then big enough I think.  Just need to send it up to urban indian to get him to put a  shine on it for me.  Also got the -10s welded on my valve cover a little while ago.  Just need to get a mount made up, move my battery and get this in the car. 

[ApexSilver06MR]

solid!

[SgtB]

Pimp shit.

[bigwig]

So this is what you needed all of that line for.

[malichite]

Yes sir!

[ratcityrex]

Pimp!

[bigdaddyvtec]

i  see wat u did thur

[snm95ls]

that's one heavy bitch, but i dig the cheapness.

[ApexSilver06MR]

So...  How much for one?  Don't need the -10 fittings though. I'm a cheapass that uses barb fittings?

[Urban Indian]

i  see wat u did thur

I could shine that

[HiProfile]

Looks awsome except maybe the baffle. I'd have drilled some holes up it's length and stuffed that part with stainless steel wool, but that's assuming the goal is to capture & condense the vapors. Any reason you had to weld both ends of the tank? I'd probably just tack the baffel at the top and again as far in as I could reach. All I can guess is the stock threaded end had shit in it you couldn't use for the vent end.

[malichite]

cut both ends off so I could tack both ends of the baffle and also I couldn't fit the bastard in my drill press with the ends on to drill them out. 

[TheMadScientist]

looks awesome! powder coat or polish it and and it'll look tits!

[malichite]

Probably just going to paint it flat black.  I'm boring and dont need any of that bling bling shit. 

[d112crzy]

Nice work. I prefer using jb weld and an old Coleman propane tank+$2 fittings at my local plumbing store.

[malichite]

Nice work. I prefer using jb weld and an old Coleman propane tank+$2 fittings at my local plumbing store.

That is pimp!!!

[ratcityrex]

Nice work. I prefer using jb weld and an old Coleman propane tank+$2 fittings at my local plumbing store.

I dig!