Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[92CXyD]

If I mill the block deck ~0.01 to 0.02 in what should adjust my cam offset by?

My setup

D16z6 block
D16z6 3-layer head gasket
D16y8 head
Vitaras 0.5mm o/s
TT rods with new rod bolts

SC14 supercharger and later a T04b s-trim turbo or something larger for a twincharge setup.

Acccording to the http://www.zealautowerks.com/dseries.html I would have too mill 0.02in
 of block to get 8.0:1 comp which I think I may need b/c I live at elev. of 5000ft and higher.

[ratcityrex]

Fuck it run it as is. I dont think it would be a huge differance. ()

[92CXyD]

I remeber reading somewhere a while back that for every 0.010 milled of your suppose to offset the cam timing a degree or two. but I do not remember the source.

[CRX304]

grab a timing light and adj accordinly... in my vitera w/ Z6 head I milled .050" (yup) and it was 4 degrees

[92CXyD]

milled 0.050 in damn here I thought 0.020 was a lot ;D

thanks for the info.

[ratcityrex]

grab a timing light and adj accordinly... in my vitera w/ Z6 head I milled .050" (yup) and it was 4 degrees

Can you elaborate a litte more on how you did this? You used a ign. timing lite to check your cam timing?

[lilpooh21186]

with your 3layer hg what is the thickness it may be thick enough to offset the mill

[turbohf]

you need to degree in your cam properly

[92CXyD]

you need to degree in your cam properly

thanks

[dvst8r]

Fuck and there is HT with tech and rHMT without, growing pains.

[crttaz]

D series 1mm (.039") = 1 degree

[92CXyD]

D series 1mm (.039") = 1 degree

I remember seeing that some where?

I am assuming cam timing you are refering to.