Topic: help!!! i need a p30 jdm pinout (Read 7496 times)

shogun · « **on:** June 10, 2009, 08:05:54 PM »

hey, im trying to plug my widband to the ecu so ectune can read afr, but i cant seem to find a pinout diagram, thank you for your help

turbohf · « **Reply #1 on:** June 10, 2009, 10:19:35 PM »

same as a P28, or anyother OBD1 ECU....

BangBusMaster · « **Reply #2 on:** June 11, 2009, 01:34:03 AM »

BoostForLife · « **Reply #3 on:** June 11, 2009, 02:46:28 AM »

D14

Usually its a thicker wire than the rest and it's WHITE at pin as stated in the quote.

Joseph Davis · « **Reply #4 on:** June 11, 2009, 08:27:22 AM »

I like using D12 better.

d112crzy · « **Reply #5 on:** June 11, 2009, 01:35:29 PM »

any reason why?

shogun · « **Reply #6 on:** June 11, 2009, 01:37:50 PM »

thanks, it doesnt change even if it is a jdm car, its a 95 sir

Joseph Davis · « **Reply #7 on:** June 11, 2009, 04:22:18 PM »

any reason why?

Already has a pull down resistor and filter cap, signal is smoother. Notice EGR lift/ELD/etc don't float high without a signal run to them.

shogun · « **Reply #8 on:** June 11, 2009, 07:11:37 PM »

found the diagram, thanks jd for the tip d14 it is

ratcityrex · « **Reply #9 on:** June 11, 2009, 07:12:57 PM »

will free log see d12?