Unsprung....
Ok, motor was out at 2:15, so little less than an hour.... awesome.....
Quickly unbolt pressure plate with fingers crossed.
Pressure plate surface was SHOOOOOOTTTTT. The disc was down to rivits and ate the shit out of the pressure plate.....
I have a new flywheel, don't care about the old one. But the pressure plate?
I was fucked.
So.....
Quickly built a jig, attached it to the rotating table on my ancient Jet mill/drill and resurfaced the pressure plate. I had to take ALOT off, so much that I also had to take 1/32" off the mounting points as well.
Ghetto Fabrication!